did not have enough counts
- Reduced polling frequency in emon
- Fixed a scriptcontext bug which would cause it to dump core in SctTransact
on interrupts
- Fixed an issue with missing <nl> at the end of batch files
- Added a feature which does not call halt when counting stops in hmcontrol.c
This is necessary for the BOA CCD
- Initalized doNotFree properly in hipadaba.c
- Added the travelling salesman reflection measurement algorithm
- Added another component to amorset
- Removed old SicsWait from nserver.c
- Added a means to nxscript to write 16 bit data for BOA
- Modified tasub to accept a drivabel as a motor and not only a motor.
This became necessary to make EIGER work as A2 on EIGER is a virtual
motor
- Added missing cnvrt files, stolen from Markus
- Debugged the new sinqhttpopt driver for SINQ HTTP HM
- Debugged the driver for the new S7 Siemens SPS
- Added handling of hexadecimal terminators to ascon.c
- Increased the write buffer size in asynnet again
- Fixed a core dump in lld.c
- Added writing of second gen HM to nxscript.c
- Added doubletime command to SICS
- Fixed a core dump issue in sicshdbadapter.c on dimension changes
- Modified sicsobj to look for lower case keys too
- Fixed exeman to write files by default into the first directory in batchpath
- Fixed a bug in nxdict which prevented it from handling attributes
containing :/ properly
- Removed junk files
- Fixed a bug in hklscan.c which made it dump core
- Added XML support to nxscript.c
- Added support for writing NeXus-XML data files to tasub
- Fixed a bug with initializing the motor controller after manula mode
- Added support to drive the first choppers phase
a connection during an active run.
- Added an additional output mode for the connection in order to
support the batch run editor.
- Made clientput send everything with eWarning mode in order to support
the batch run editor.
- Added a better NetReadTillTerm
- Fixed a problem in synchronize.c
- Fixed an issue with reading empty line on normal connection sockets.
- Added a psi scan mode to mesure.c for TRICS
- Made motor print warnings when trying to reposition.
- Fixed abug in hkl.c which cause wrong signs.
- Added fulltransact which sends a TRANSACTIONSTART meesage in addition to
TRANSASCTIONFINISHED
- Added parameter to motor which allows to ignore positioning faults
- ADDED POLAN support to tasscan
