48 lines
1.4 KiB
Batchfile
Executable File
48 lines
1.4 KiB
Batchfile
Executable File
#!../../bin/linux-x86-debug/sinqEPICS
|
|
|
|
|
|
## You may have to change sinqEPICS to something else
|
|
## everywhere it appears in this file
|
|
|
|
< envPaths
|
|
|
|
cd ${TOP}
|
|
|
|
## Register all support components
|
|
dbLoadDatabase "dbd/sinqEPICS.dbd"
|
|
#dbLoadDatabase "dbd/sinq.dbd"
|
|
sinqEPICS_registerRecordDeviceDriver pdbbase
|
|
|
|
## Load record instances
|
|
#dbLoadRecords("db/xxx.db","user=koenneckeHost")
|
|
|
|
|
|
#---------- load Nanotec motor controller
|
|
#drvAsynIPPortConfigure("serial1", "narziss-ts:3002",0,0,0)
|
|
drvAsynIPPortConfigure("serial1", "boa-ts:3014",0,0,0)
|
|
#drvAsynIPPortConfigure("serial1", "localhost:2020",0,0,0)
|
|
NanotecCreateController("nano","serial1","1","11");
|
|
|
|
### Motors
|
|
|
|
dbLoadRecords("$(ASYN)/db/asynRecord.db","P=KM36:,R=serial1,PORT=serial1,ADDR=0,OMAX=80,IMAX=80")
|
|
|
|
#------------------------------------------------------------------------------
|
|
# DANGER DANGER DANGER
|
|
#
|
|
#If the gearing factor in the substitutions file is wrong, then the nanotec
|
|
# drives badly. Not really a surprise. Thus the following procedure is required:
|
|
#
|
|
# - After editing the gearing ratios in the substitutions file, drive each motor
|
|
# carefully for a small amount and check if it is driving the correct amount by
|
|
# eye.
|
|
#------------------------------------------------------------------------------
|
|
cd ${TOP}/iocBoot/${IOC}
|
|
dbLoadTemplate "motor.substitutions.nanoboa"
|
|
|
|
|
|
iocInit
|
|
|
|
## Start any sequence programs
|
|
#seq sncxxx,"user=koenneckeHost"
|