forked from epics_driver_modules/motorBase
Ron Sluiter
31 lines
1.0 KiB
Plaintext
31 lines
1.0 KiB
Plaintext
# RELEASE - Location of external products
|
|
#
|
|
# (Architecture dependent declarations should go into RELEASE.<arch>)
|
|
#
|
|
# Note: This file will be scanned to automatically generate
|
|
# include path definitions etc.
|
|
# The order of the following declarations will be retained
|
|
# within those definitions.
|
|
#
|
|
# Add your declarations here
|
|
|
|
SUPPORT=/local/epics/3.13.2/support
|
|
|
|
# Define the following if MPF is defined and serial motor controller
|
|
# support is required.
|
|
#MPF_SERIAL=$(SUPPORT)/mpfSerial/mpfSerial1-1
|
|
|
|
# If the EPICS GPIB Module from Benjamin Franksen is used, then remove the '#'
|
|
# from the following and modify the motorApp/CommSrc/Makefile.Vx file per
|
|
# instructions found there. If GPIB driver support is from EPICS base, then
|
|
# leave this line commented out.
|
|
#GPIB=$(SUPPORT)/gpib
|
|
|
|
# If any motor controller communication mechanism besides the
|
|
# VME backplane is required, then either MPF or HIDEOS must
|
|
# be defined.
|
|
#MPF=$(SUPPORT)/mpf/mpf1-5
|
|
#HIDEOS=$(SUPPORT)/hideos/install
|
|
|
|
#EPICS_BASE=$(SUPPORT)/base/3-13-2
|