"""
TEST: OTF scan for mono calibration

under development - does not run yet

tasks:
- find out positioner of beta angle and set up device (must be of motor class).
- load table of scan positions.
- add outer theta loop.
"""

MOTORS = (MonoBeta)
SENSORS = (SampleCurrent, RefCurrent, MachineCurrent)
STARTPOS = (beta1)
ENDPOS = (beta2)
TIME = 120.0 # seconds
STEPS = 1000
RELATIVE = False
ENDSCAN = False

adjust_sensors()
set_adc_averaging()

def trig_sensors():
    caput("X03DA-OP-10ADC:TRG.PROC", 1)
    
try:
    wait_beam()
    cscan(MOTORS, SENSORS, STARTPOS, ENDPOS, STEPS, time = TIME, relative = RELATIVE, before_read = trig_sensors)
finally:
    if ENDSCAN:
        after_scan()