35 lines
1.5 KiB
HTML
35 lines
1.5 KiB
HTML
<HTML>
|
|
<HEAD>
|
|
<TITLE>TRICS specific Count and Scan Command </TITLE>
|
|
</HEAD>
|
|
<BODY>
|
|
<H1>PSD-TRICS Count and Tricsscan Command</H1>
|
|
<P>
|
|
Two special commands have been defined for TRICS with a PSD:
|
|
<dl>
|
|
<dt>count <tt>mode preset </tt>
|
|
<dd>counts with all three detectors. The parameter mode defines which
|
|
counting mode is used, supported are <b>preset</b> for counting up to a
|
|
preset monitor or <b>timer</b> for counting for a specified time intervall.
|
|
The second prameter preset is either the preset monitor or the preset
|
|
counting time, depending on the mode choosen. Both parameters are
|
|
optional, if they are notc specified values from the last run will be used.
|
|
count does not store any data.
|
|
<dt>tricsscan <tt>start step np mode preset</tt>
|
|
<dd>This command creates a new data file and then performs a scan in omega,
|
|
storing meausured data after each step. <tt>start step np</tt> define the
|
|
scan range in omega. Start is the start position, step the step width to
|
|
use and np is the number of steps to do. The optional parameters mode and
|
|
preset have the same meaning as in the count command described above.
|
|
Mode and preset how data is collected at each step in omega.
|
|
<dt>psdrefscan filename step np mode preset
|
|
<dd>reads reflection HKL values from file filename and performs
|
|
tricsscans for each reflection. These will be done eith step width
|
|
step, the number of steps np with counting mode mode and a preset of
|
|
preset. These parameters have the same meaning as described above.
|
|
</dl>
|
|
</P>
|
|
|
|
</BODY>
|
|
</HTML>
|