deviceDesc = dry system

if {"[sicsdescriptor t]" != "notfound"} {
clientput [listexe]
  stopexe t
clientput success
  success
clientput "removeobject t"
  removeobject t
}

# --- configuration script
config listen 1

# create the device
# change X77456 for X154360 when calibration exists

## Configuration for attocube testing:
#makenv tt -driver [lsdriver] {
#  lsc_sensor tm A -sensor X71741 -sensorname top
#  lsc_sensor ts B -sensor X68433 -sensorname bottom  
#  lsc_sensor tc C -sensor X154360 -sensorname middle
#  lsc_loop set -loop 1 -channel B -maxheater 25W -resist 25Ohm
#}

# Configuration for braid thermal conductivity measurements:
makenv tt -driver [lsdriver] {
  lsc_sensor ts B -sensor X154360 -sensorname stage2  
  lsc_loop set -loop 1 -channel B -maxheater 25W -loopname braid -resist 50Ohm
}

tt set/limit 315
tt set/prop 15
tt set/integ 10
catch {
  enableTable 0
}


 makenv tx -driver 370_lsc {
  lsc_sensor S1 -channel 1 -sensor ruox002
  lsc_sensor S2 -channel 3 -sensor ruox001
  #please set sample Thermpmeter to the real calib
  GraphAdd tx.S1 K S1 yellow
  GraphAdd tx.S2 K S2 cyan
}



# --- compressor ---
makenv cp2800 cp2800

GraphAdd cp2800.inp_water_t C InpWater_C red
GraphAdd cp2800.out_water_t C OutWater_C blue
GraphAdd cp2800.oil_t       C Oil_C      green
GraphAdd cp2800.helium_t    C Helium_C   magenta

GraphAdd cp2800.high_side_p_min psi High_psi_min red
GraphAdd cp2800.high_side_p_max psi High_psi_max orange
GraphAdd cp2800.low_side_p_min psi Low_psi_min green
GraphAdd cp2800.low_side_p_max psi Low_psi_max dark_green