# RELEASE - Location of external products
#
# (Architecture dependent declarations should go into RELEASE.<arch>)
#
# Note: This file will be scanned to automatically generate
#       include path definitions etc.
#       The order of the following declarations will be retained
#       within those definitions.
#
# Add your declarations here

#SUPPORT=/usr/local/epics/3.13.2/support

# Define the following if MPF is defined and serial motor controller
# support is required.
#MPF_SERIAL=$(SUPPORT)/mpfSerial/mpfSerial1-1

# If the EPICS GPIB Module from Benjamin Franksen is used, then remove the '#'
# from the following and modify the motorApp/CommSrc/Makefile.Vx file per
# instructions found there.  If GPIB driver support is from EPICS base, then
# leave this line commented out.
#GPIB=$(SUPPORT)/gpib

# If any motor controller communication mechanism besides the
# VME backplane is required, then either MPF or HIDEOS must
# be defined.
#MPF=$(SUPPORT)/mpf/mpf1-5
#HIDEOS=$(SUPPORT)/hideos/install

#EPICS_BASE=$(SUPPORT)/base/3-13-2

# The following must be defined if motorExApp is to be built.
#TEMPLATE_TOP=$(EPICS_BASE)/templates/makeBaseApp/top
#MSITOP=/usr/local/epics/extensions