diff --git a/RELEASE.txt b/RELEASE.txt
index 6e83acd6c..fe0657a8a 100644
--- a/RELEASE.txt
+++ b/RELEASE.txt
@@ -1,7 +1,7 @@
-SLS Detector Package Major Release 7.0.2 released on 12.07.2023
+SLS Detector Package Major Release 7.0.3 released on xx.xx.2023
 ===============================================================
 
-This document describes the differences between v7.0.2 and v7.0.1   
+This document describes the differences between v7.0.3 and v7.0.2   
 
 
 
@@ -19,62 +19,6 @@ This document describes the differences between v7.0.2 and v7.0.1
 =================
 
 
-    Firmware
-    --------
-
-    *   [Jungfrau] Stopping acquisition in sync mode
-        Previously, stopping acquisition in sync mode would result in the slave
-        status remaining in Running status for next acquisition and framesl (frames
-        left) would be stuck from the previous acquisition. This is fixed in firmware.
-  
-
-
-    Detector Server
-    ---------------
-
-    *   [Jungfrau] Changing master to slave in sync mode
-        When in sync mode, changing from master to slave would change the status
-        to Running in firmware. A workaround in the detector server fixes this.
-
-    *   [Jungfrau] Row and column for multi module Jungfrau 
-        This mainly affected only the GUI, unless one was using the row and column
-        sent out by the detector. Row and column values were mixed up, but fixed now.
-
-    *   [Jungfrau] Timing in sync mode
-        When sync is enabled, setting or getting timing would give an error. This 
-        is fixed now.
-
-
-    Client
-    ------
-
-    *   [Jungfrau] Multi module sync mode
-        For start, stop and trigger acquisition, the procedure to start the slaves
-        (or the master for stop acquisition) first had to be obeyed. This is fixed
-        now.
-    
-
-    ZMQ
-    ---
-
-    *   [Jungfrau][Gotthard2] Client ZMQ port when using 2 interfaces
-        When switching between 1 and 2 interfaces, the client or gui zmq port
-        was not set properly and resulted in dummy streaming forever. This is
-        fixed now.
-
-    *   Rx_roi
-        This parameter is now also streamed in the zmq header to be able to use in 
-        external GUIs.
-
-
-    GUI
-    ---
-
-    *   [Jungfrau] Show Fix_G0 in expert mode
-        Fix_G0 was only shown when expert mode was enabled from Settings Tab. Now, 
-        fixed to show when expert mode enabled from any tab.
-
-    
 
 
 2  On-board Detector Server Compatibility