mirror of
https://github.com/slsdetectorgroup/slsDetectorPackage.git
synced 2025-04-23 23:10:02 +02:00
manual
This commit is contained in:
parent
c89fad45a9
commit
c5178bc4de
BIN
manual/manual-client/Eiger-Chips.png
Normal file
BIN
manual/manual-client/Eiger-Chips.png
Normal file
Binary file not shown.
After Width: | Height: | Size: 34 KiB |
@ -156,6 +156,14 @@ outdir /sls/X12SA/data/x12saop/Data10/Eiger0.5M
|
|||||||
threaded 1
|
threaded 1
|
||||||
\end{verbatim}
|
\end{verbatim}
|
||||||
|
|
||||||
|
The geometry on af an EIGER module, showing the quadrants corresponding to the udp ports and the 2 receivers is shown in figure~\ref{fig:eigerports}.
|
||||||
|
\begin{figure}[t]
|
||||||
|
\begin{center}
|
||||||
|
\includegraphics[width=0.9\textwidth]{Eiger-Chips}
|
||||||
|
\end{center}
|
||||||
|
\caption{Geometry of UDP ports and receivers in a singel module.}
|
||||||
|
\label{fig:eigerports}
|
||||||
|
\end{figure}
|
||||||
|
|
||||||
In the case you are developing your own receiver, then you need to remove the 1Gb receiver hostname {\tt{rx\_hostname}} and substitute it with the mac address of the device:
|
In the case you are developing your own receiver, then you need to remove the 1Gb receiver hostname {\tt{rx\_hostname}} and substitute it with the mac address of the device:
|
||||||
\begin{verbatim}
|
\begin{verbatim}
|
||||||
@ -163,7 +171,6 @@ configuremac 0
|
|||||||
rx_udpmac xx:xx:...
|
rx_udpmac xx:xx:...
|
||||||
\end{verbatim}
|
\end{verbatim}
|
||||||
|
|
||||||
|
|
||||||
One can configure all the detector settings in a parameter file {\tt{setup.det}}, which is loaded by doing:
|
One can configure all the detector settings in a parameter file {\tt{setup.det}}, which is loaded by doing:
|
||||||
\begin{verbatim}
|
\begin{verbatim}
|
||||||
sls_detector_put 0-parameters setup.det
|
sls_detector_put 0-parameters setup.det
|
||||||
@ -712,7 +719,7 @@ To activate back a module, do:
|
|||||||
\end{verbatim}
|
\end{verbatim}
|
||||||
|
|
||||||
\end{itemize}
|
\end{itemize}
|
||||||
\subsection{Setting up 10Gb and the PC settings for highframe rate experiments}\label{10g}
|
\section{Setting up the PC settings for 10Gb}\label{10g}
|
||||||
|
|
||||||
For configuring well the 10Gb card not to loose packets,
|
For configuring well the 10Gb card not to loose packets,
|
||||||
\begin{itemize}
|
\begin{itemize}
|
||||||
|
Loading…
x
Reference in New Issue
Block a user