updated release notes

RELEASE.txt

@@ -19,19 +19,89 @@ This document describes the differences between v7.0.3 and v7.0.2
 =================
 
 
+    Firmware
+    --------
+
+    *   [Eiger] Blocking trigger on quad
+        Previously, blocking software trigger on a quad was not blocking. Fixed
+        with firmware v32.
+
+
+
+    Client
+    ------
+
+    *   Limit port number max of 65535
+        Previously, one could set the port numbers (TCP, UDP, ZMQ) to values 
+        higher than 65535 and also to 0. However, it was truncated to 16 bit
+        in the background, but not relayed to the user. 
+        Now, it will throw if it is 0 or greater than 65535 (16 bit).
+
+    *   Stopping acqusition for a single or subset of modules
+        The Detector API previously stopped all modules.
+        Now, it takes into account which modules the user wanted to stop.
+
+    *   [Jungfrau] Stop in sync mode
+        When stopping acquisition in sync mode, only the master module sometimes 
+        returns 'Idle' state instead of 'Stopped'. The software threw an 
+        exception for the different states then.
+        Now, it does not throw and a fix will be added to the next firmware 
+        release for the different states (with SW release: v8.0.0).
+
+    *   [Eiger] Error in Stop
+        When stopping acquisition, if a half module were to give an error in a 
+        rare case while the others succeeded, this would result in an re-attempt 
+        to stop 9 more times before throwing an incorrect exception that it 
+        could not stop.
+        Now, it is handled and will throw an exception of the error status
+        immediately.
+
+
+
+    Receiver
+    --------
+
+    *   Limit TCP port number (command line) to max of 65535
+        Refer issue under 'Client'.
+
+    
+    Detector Simulator
+    ------------------
+
+    *   Limit TCP port number (command line) to max of 65535
+        Refer issue under 'Client'.
+
+
+    Gui
+    ---
+
+    *   [Jungfrau] Color map of gain plot
+        Previously, color on the gain plot did not update after the first image, 
+        unless there were x/y min/max changes or window resizing. Fixed.
+
+
+    Data Processing
+    ---------------
+
+    *   [Moench] Segmentation fault with moench03RawDataPrcess
+        Previously, it crashed when nframes > 0. Fixed.
+
+    *   [Moench] Moench interpolation issues fixed.
+
+
 
 
 2  On-board Detector Server Compatibility
 ==========================================
 
 
-    Eiger       7.0.0
-    Jungfrau    7.0.2
-    Mythen3     7.0.0
-    Gotthard2   7.0.0
-    Gotthard    7.0.0
-    Moench      7.0.0
-    Ctb         7.0.0
+    Eiger       7.0.3
+    Jungfrau    7.0.3
+    Mythen3     7.0.3
+    Gotthard2   7.0.3
+    Gotthard    7.0.3
+    Moench      7.0.3
+    Ctb         7.0.3
     
 
     On-board Detector Server Upgrade