diff --git a/Setup-Computer-Debian-12.md b/Setup-Computer-Debian-12.md
index 77977fa..1b53984 100644
--- a/Setup-Computer-Debian-12.md
+++ b/Setup-Computer-Debian-12.md
@@ -87,7 +87,7 @@ make
   export EPICS_CA_ADDR_LIST="sls-x07da-cagw.psi.ch:5822"
 
 
-sudo cp ~/work/stxm/SystemInstall/epics-7.0.6.conf /etc/ld.so.conf.d
+sudo cp ~/work/stxm/SystemInstall/epics/epics-7.0.6.conf /etc/ld.so.conf.d
 # edit to match lib Path
 sudo ldconfig
 ```
@@ -96,7 +96,7 @@ sudo ldconfig
 
 ```
 cd ~/Basesystem
-tar xfvj ../work/stxm/SystemInstall/PI_Application_Software-1.17.0.1-INSTALL.tar.bz2
+tar xfvj ../work/stxm/SystemInstall/HW-Libs/PI_Application_Software-1.17.0.1-INSTALL.tar.bz2
 cd PI_Application_Software/
 sudo ./INSTALL
 #n
@@ -113,21 +113,8 @@ sudo ./INSTALL
 ```
 cd /usr/local
 sudo mkdir intens
-sudo tar xfvz ~/work/stxm/SystemInstall/intens-4.5.15-snapshot-64-qt5.tar.gz 
-sudo cp ~/work/stxm/SystemInstall/libpython3.8.so.1.0 /lib/x86_64-linux-gnu/
-```
-
-
-- Load Comedi driver and configure cards 
-
-Note: Again, only needed if Agilent interferometer card needs to be supported. This step turns off the auto-loading of driver modules and sets a manual list of modules to be loaded. This list may need to be [adapted to the available hardware](Orocos-Configuration).
-
-```
-sudo cp ~/work/stxm/SystemInstall/ComediLoadModules /etc/init.d
-cd /etc/rc5.d
-sudo ln -s ../init.d/ComediLoadModules S98ComediLoadModules
-
-sudo cp ~/work/stxm/SystemInstall/comedi.conf /etc/modprobe.d
+sudo tar xfvz ~/work/stxm/SystemInstall/intens/intens-4.5.15-snapshot-64-qt5.tar.gz 
+sudo cp ~/work/stxm/SystemInstall/intens/libpython3.8.so.1.0 /lib/x86_64-linux-gnu/
 ```